Well another day, not much done unfortunately. However I did find enough wherewithall to get the woodwork on the table done. I realised that the table was too big and that I had to make is more manageable, so as I said in my last post, I decided to cut it into three. This has worked very well and will make the table very useable as well as not taking up too much room ath the front of the bus. The pic below shows where I cut it.
The pic below is the table folded to show how it will fit between the dinette seats. The middle section is 340mm x 600mm and although I don't have the pole to put it on yet, I reckon it will go just fine.
The next pic is the table upside down. This shows the hinges and the reinforcing pieces that I put on the bottom side. I will have to use these pieces of 42 x 19 to support some bolts or other means of keeping the table opened up. I haven't worked this one out yet.
I also got some staining started today, its all looking fine and once the varnish is on should come up very well. The pic below is of the back wall of the shower and the adjoining overhead cupboard.
This one is of course the back and right side rear backrests just to show how the staining looks.
